I want to modify the fatigue levels of my rider because i'm close to the tour and my strongest rider is totaly tired because the new training system is kinda difficult for me.
How can i modify it. Theres no Hannes Converter yet so i dont know what to do.
Is it possible with the full editor from Eyolfur?
And what means "Skip Dyn_fatigue". I don't understand it in the readme.
For what is this table important? In PCM 07 it wasnt necessary to modify this table.
greetz
jd2k
Edited by JayDee2k on 21-06-2008 17:20
There is a "Skip DYN_fatigue" box because the DYN_fatigue table contains a lot of data and takes a lot of time to load. So you can skip it if you don't need to look at it.
I will have a look at a savegame now, just so I can point you in the right direction
Later on I will write a proper guide on how to get the Advanced Editor working, and then some small guides on how to do tasks like thisEdited by Addy291 on 21-06-2008 17:25
To be honest I don't have a savegame where anyone has actually accumalated any fatigue, so I don't know what's inside the DYN_fatigue table.
However if you go into DYN_cyclist, locate your cyclist(s) and then scroll accross to just past halfway, you will see 2 columns named "fitness_f_forme_fatigue" and "fitness_f_forme_fatigue_cumul". As I said, I haven't gone far enough in my career for anyne to have any fatigue, but I'd guess that these are the columns that you need to edit.
If you don't quite understand it, upload your savegame, and I will have a look for you
thanks a lot. i have set "fitness_f_forme_fatigue" = 0 and my rider was totally fit again.
i marked "skip dyn_fatigue". i think i dont need it. but my new database is smaller now.
its because i skipped the dyn_fatigue table. is it a problem that the dyn_fatigue table is missing in my database or is it unnecessary for my savegame.... ?!?!?
Edited by JayDee2k on 21-06-2008 18:47
